Kannettavassani on SMC2835W pcmcia WLAN-sovitin, johon kernelissä on valmiina "toimiva" prism54 ajuri ja laite tunnistautuu oikein.
En saa kuitenkaan langatonta yhteyttä toimimaan Linksys WLAN Routeriin.
Routterin asetukset on kohdillaan(kortti toimii Windowsin kanssa), käytössä WEP-salaus ja DHCP.
Saattaisi toimia ndiswrapperilla, mutta haluaisin toimia vapaan lähdekoodin pohjalta...
Kysymys on siis legendaarinen "Mitä pitäis tehdä?"
Seuraavassa eri komentojen tulosteita:
dmesg (lopusta)
[17187310.528000] eth1: uploading firmware...
[17187310.620000] eth1: firmware version: 1.0.4.3
[17187310.620000] eth1: firmware upload complete
[17187310.812000] eth1: resetting device...
[17187310.812000] eth1: uploading firmware...
[17187310.912000] eth1: firmware version: 1.0.4.3
[17187310.916000] eth1: firmware upload complete
[17187311.068000] eth1: interface reset complete
[17187321.608000] eth1: no IPv6 routers present
lspci -v (pätkä)
0000:02:00.0 Network controller: Intersil Corporation Intersil ISL3890 [Prism GT/Prism Duette] (rev 01)
Subsystem: Intersil Corporation: Unknown device 0000
Flags: bus master, medium devsel, latency 80, IRQ 11
Memory at 12000000 (32-bit, non-prefetchable) [size=8K]
Capabilities: [dc] Power Management version 1
iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
sit0 no wireless extensions.
eth1 IEEE 802.11b/g Mode:Managed Frequency:2.452 GHz
Access Point: Not-Associated Bit Rate:0 kb/s Tx-Power=31 dBm
Sensitivity=20/200
Retry min limit:8 RTS thr:2347 B Fragment thr:2346 B
Link Quality:0 Signal level:0 Noise level:121
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
ifconfig (pätkä)
eth1 Link encap:Ethernet HWaddr 02:10:91:01:3F:26
inet6 addr: fe80::10:91ff:fe01:3f26/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:6624 (6.4 KiB)
Interrupt:11
cat /etc/network/interfaces
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
iface eth0 inet dhcp
iface eth1 inet dhcp
wireless-essid kotiwlan
wireless-key s:"tässä näkyy oikea salasanani"
auto eth1
cat /etc/hosts
127.0.0.1 localhost ArmadaE500
127.0.1.1 ArmadaE500.elisa-laajakaista.fi ArmadaE500
# The following lines are desirable for IPv6 capable hosts
::1 ip6-localhost ip6-loopback
fe00::0 ip6-localnet
ff00::0 ip6-mcastprefix
ff02::1 ip6-allnodes
ff02::2 ip6-allrouters
ff02::3 ip6-allhosts
192.168.1.1 wlan routteri (tämän olen itse lisännyt)
sudo /etc/init.d/networking restart
Listening on LPF/eth1/02:10:91:8b:2b:c8
Sending on LPF/eth1/02:10:91:8b:2b:c8
Sending on Socket/fallback
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 5
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 12
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 20
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 10
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 14
No DHCPOFFERS received.
No working leases in persistent database - sleeping.
Olen koittanut myös:
sudo route add -net 192.168.1.0 netmask 255.255.255.0 dev eth1Ei vaikuttanut.
