Dapper: Packard-Bell IMEDIA MC H1519, TV7131 Hybrid TV-Tuner, ei tunnista

[Hende]

Olen käyttänyt Dapperia menestyksekkäästi kaikkeen mitä perhe voi toivoa, mutta tv:n kanssa on ongelmia, niin KDETV:n kuin TVTimenkin kanssa.

Koneeni on Packard-Bell IMEDIA MC H1519, ja siinä on TV-korttina TV7131 Hybrid TV-Tuner (alla tarkemmat tiedot), jossa on saa7131 jne.

Koetin Näillä ohjeilla (http://tvtime.sourceforge.net/problems.html#undetected) laittaa samanlaisen lastun sisältävien korttien konfiguraatiota mm. 39, mutta eipä pelittänyt, vaan kortin numero pysyi nollana. Onko joku onnistunut, tai olisiko hyviä vinkkejä ?

TV-7131/FM Hybrid TV Tuner

Specifications
Hardware

    * Philips TDA8275A tuner with TDA10046 as DVB-T demodulator
    * FM radio tuner included with TDA8275A
    * Philips SAA7131 analogue A/V decoder/analogue demodulator for NTSC/PAL/SECAM signals
    * PCI interface SAA7131 with DMA controller and I2C tuning control
    * PCI revision 2.2-compliant
    * Analogue video is sampled by ADCs, decoded by multi-line adaptive comb filter

Connectors

    * FM radio signal input for FM antenna
    * Cable or antenna input (RF signal input)
    * Audio/video input for Spider Cable:
          o Audio L/R RCA input
          o S-Video mini-DIN
          o Composite RCA video input
    * Internal TV audio output

Features

    * The TDA8275A is a single conversion full band tuner with a phase lock loop tuning system. The PLL tuning system is I2C programmable and allows a number of different tuning step sizes such as 166.67 KHz for digital and 62.5 KHz & 50 KHz for analogue applications.
    * The TDA10046 is a single chip channel receiver for 2K and 8K COFDM modulated signals based on the ETSI specification (ETSI 300 744). The device performs all the COFDM demodulation tasks from the IF signal (first or second IF) to the MPEG2 transport stream. Support 6/7/8 MHz channels with same board.
    * The stereo decoder circuit uses the SAA7131. The SAA7131 audio samples at 32 KHz, 44.1 KHz or 48 KHz rate and is routed to the SAA7131 audio-out pins.
    * The video decoder of SAA7131 uses a 2D comb filter to minimize video artifacts. The ability of capture raw VBI data can implement Macrovision.
    * The PCI interface uses the SAA7131 and uses a DMA controller that is used to bus master data to the host. SAA7131 acts as analogue audio/video decoder function.

System Requirements

    * Microsoft Windows 2000 / XP / MCE
    * DirectX 8

Capture Resolution Table
Video Standard   Supported Resolution
PAL / SECAM   720x576, 720x480, 720x288,
720x240, 704x576, 640x480,
640x288, 640x240, 352x288,
352x240, 320x240, 240x180,
240x176, 176x144, 160x120
Internal Connectors
Name   Function   Type
JP2   Audio L/R connector   4-pin header (white)
JP5   Front I/O audio/video connector   10-pin header (white)
External Connectors
Name   Function   Type
RF-IN   TV RF input   RF (female)
FM-IN   FM connector   RF (male)
Audio/Video In   S-Video   9-pin mini-DIN (female)