Xgl - poistettu ja nyt X sekaisin

[Krisseck]

Hiukan sekavan oloinen otsikko mutta luultavasti ajaa asian.

Eli tuli kokeiltua tuota Compizia.
http://ubuntuguide.org/wiki/Dapper#How_to_install_Xgl.2FCompiz_.28Nvidia.29
Tuon perusteella asensin sen ja hyvin toimi. Mutta OpenGL pelit yms eivät tahtoneet toimia, tai sitten oli huonot fps:ät, niin päätin poistaa sen.

Otin Xorgin backupin ja tein siitä oikean, samoin tein /etc/gdm/gdm.conf-customille.
Poistin thefuturen että se ei käynnisty gnomen käynnistyksen ohessa.
Sitten tein vielä

Koodia: [Valitse]

sudo apt-get remove compiz  libglitz-xgl1 compiz-gnomeEhdotti samalla muitakin paketteja, poistin nekin.

Mutta nyt.
Kun käynnistin koneen uudelleen, niin kone vieläki haluaisi avata Xgl:n.

Mistä tuo X tietää käynnistää Xgl:n?

[jnr21]

Onhan gdm.conf-custom nyt varmasti tämännäköinen:

Koodia: [Valitse]

# GDM Configuration Customization file.
#
# This file is the appropriate place for specifying your customizations to the
# GDM configuration.   If you run gdmsetup, it will automatically edit this
# file for you and will cause the daemon and any running GDM GUI programs to
# automatically update with the new configuration.  Not all configuration
# options are supported by gdmsetup, so to modify some values it may be
# necessary to modify this file directly by hand.
#
# To hand-edit this file, simply add or modify the key=value combination in
# the appropriate section in the template below.  Refer to the comments in the
# gdm.conf file for information about each option.  Also refer to the reference
# documentation.
#
# If you hand edit a GDM configuration file, you should run the following
# command to get the GDM daemon to notice the change.  Any running GDM GUI
# programs will also be notified to update with the new configuration.
#
# gdmflexiserver --command="UPDATE_CONFIG <configuration key>"
#
# For example, the "Enable" key in the "[debug]" section would be specified by
# "debug/Enable".
#
# You can also run gdm-restart or gdm-safe-restart to cause GDM to restart and
# re-read the new configuration settings.  You can also restart GDM by sending
# a HUP or USR1 signal to the daemon.  HUP behaves like gdm-restart and causes
# any user session started by GDM to exit immediately while USR1 behaves like
# gdm-safe-restart and will wait until all users log out before restarting GDM.
#
# For full reference documentation see the gnome help browser under
# GNOME|System category.  You can also find the docs in HTML form on
# http://www.gnome.org/projects/gdm/
#
# NOTE: Lines that begin with "#" are considered comments.
#
# Have fun!

[daemon]

[security]

[xdmcp]

[gui]

[greeter]

[chooser]

[debug]

[servers]