Pitäisi saada läppärin sisäinen 3G toimimaan Ubuntu 10.04 Lucidissa. Kernel on 2.6.32-28. Kone on HP Compac Mini 110c-1120SO.
Aiemmassa viestiketjussa (Pitäisi saada sisäinen 3G toimimaan läppärissä) ei ollut ratkaisua tähän ongelmaan Karmicin kanssa, mutta oiskohan Lucidin tai uudempien versioiden kanssa ratkaisua?
Tulosteet on lähes samat kuin aiemmassa viestiketjussa eli:
lsusb
Bus 005 Device 002: ID 03f0:2a1d Hewlett-Packard
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 002: ID 046d:c52f Logitech, Inc.
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 004: ID 03f0:241d Hewlett-Packard
Bus 001 Device 003: ID 174f:110b Syntek
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
ja
sudo lsusb -v -d 03f0:241d
Bus 001 Device 004: ID 03f0:241d Hewlett-Packard
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
idVendor 0x03f0 Hewlett-Packard
idProduct 0x241d
bcdDevice 0.02
iManufacturer 3 Qualcomm Incorporated
iProduct 2 HP un2420 Mobile Broadband Module
iSerial 0
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 32
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 1 Qualcomm Configuration
bmAttributes 0xe0
Self Powered
Remote Wakeup
MaxPower 500mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 1
bAlternateSetting 0
bNumEndpoints 2
bInterfaceClass 255 Vendor Specific Class
bInterfaceSubClass 255 Vendor Specific Subclass
bInterfaceProtocol 255 Vendor Specific Protocol
iInterface 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 32
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x01 EP 1 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0200 1x 512 bytes
bInterval 32
Device Qualifier (for other device speed):
bLength 10
bDescriptorType 6
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
bNumConfigurations 1
Device Status: 0x0001
Self Powered
Ja nm-toolilla seuraava luettelo:
NetworkManager Tool
State: connected
- Device: eth1 [Auto WNAPf2] --------------------------------------------------
Type: 802.11 WiFi
Driver: wl
State: connected
Default: yes
HW Address: 0C:60:76:51:AC:09
Capabilities:
Speed: 54 Mb/s
Wireless Properties
WEP Encryption: yes
WPA Encryption: yes
WPA2 Encryption: yes
Wireless Access Points
WNAPf2: Infra, 00:1A:9F:94:D7:F2, Freq 2422 MHz, Rate 0 Mb/s, Strength 100 WPA WPA2
IPv4 Settings:
Address: 192.168.1.101
Prefix: 24 (255.255.255.0)
Gateway: 192.168.1.254
DNS: 192.168.1.254
- Device: eth0 -----------------------------------------------------------------
Type: Wired
Driver: atl1c
State: unavailable
Default: no
HW Address: 00:26:55:CE:03:44
Capabilities:
Carrier Detect: yes
Wired Properties
Carrier: off
Eli käytössä oleva wlan näkyy mutta ei mitään tietoa sisäisestä 3G:stä, kuten ei edellisessäkään viestiketjussa.
Oisko jelppiä kenelläkään asiasta??