ASUS P5B-VM LAN asetukset

[ilkkak]

feisty + 2.6.20-16-generic kernel

ko. emossa olevan verkkokortin ajuri ja full duplex-asetukset

~$ sudo lspci | grep -i ethernet
02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 01)


~$ sudo ethtool -i eth0
driver: r8169
version: 2.2LK
firmware-version:
bus-info: 0000:02:00.0

~$ sudo ethtool eth0
Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Advertised auto-negotiation: Yes
        Speed: 100Mb/s
        Duplex: Half
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: pumbg
        Wake-on: g
        Current message level: 0x00000033 (51)
        Link detected: yes


pitäisi olla DUPLEX: FULL


~$sudo ethtool -s eth0 speed 100 duplex full

asettaa edellä olevan

~$sudo ethtool -s eth0 speed 100 duplex full autoneg off

asettaa
~$ sudo ethtool eth0
Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  100baseT/Full
        Advertised auto-negotiation: Yes
        Speed: Unknown! (0)
        Duplex: Half
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: pumbg
        Wake-on: g
        Current message level: 0x00000033 (51)
        Link detected: yes



Ei siis onnistu: eikö ko. ajuri tue adapteria 100FD-asetuksilla vai missä vika? Lienee turha mainita, että kytkimen portti on asennossa 100FD.

Kysessä on LTSP-palvelin, johon pitäisi saada kunnon verkkoyhteys. Yksi tapa olisi tietysti laittaa koneeseen paremmin tuettu verkkokortti, mutta yritetään ensin näin. Vihjeitä?