Haluaisin ostaa tuommoisen, tai on jo tilauksessa http://www.jimmspc-store.fi/tuote/UHB-2MP mutta toimiiko tuo ubuntussa 7.10 ? jos ei, niin löytyykö mitään vastaavaa, joka toimii?
Vehje on nyt ostettu ja apua tarvitsisin, eli tuossa on asennusohje linuxiin:
/*** Installation guide for Linux ***/
This document was modified from "
http://www.linux-usb.org/USB-guide/book1.html" which was written by Brad Hards.
System Requirement:
1. kernel versions 2.2.7 and later contain the USB code.
Install Card Reader step by step:
1. configure USB into kernel. Use of "make menuconfig" is recommended.
Under "USB support", you need to select "Support for USB". You also need to
select either UHCI (Intel PIIX4, VIA, ...) support, UHCI Alternate Driver (JE) support
or OHCI-HCD (Compaq, iMacs, OPTi, SiS, ALi, ...) support. Which one you select is
dependent on what kind of motherboard or adapter you have.
2. select "USB Mass Storage support"
3. select "Preliminary USB Device Filesystem"
4. select "SCSI support"
5. selct "SCSI disk support"
6. select "/proc support"
7. Rebuild the kernel and the modules (if you configured to build as modules),
and install the new kernel and the new modules. Reboot the system.
If you are using modules, you need to load the following modules:
a. usbcore.o
b. usb-uhci.o, uhci.o or usb-ohci.o
c. usb-storage.o
Inspect the kernel logs. If there isn't anything that could be USB related,
likely causes are use of the wrong driver (UHCI when you needed OHCI or
OHCI when you needed UHCI), not physically installing the hardware,
a BIOS configuration that disables USB or stuffing up the configuration or
installation of the kernel.
8. Use the mount command: mount -t usbdevfs none /proc/bus/usb.
Note that the 'none' keyword is arbitrary.
If you do not want to have to mount the filesystem each time you reboot the system,
you can add the following to /etc/fstab after the /proc entry.
none /proc/bus/usb usbdevfs defaults 0 0
9. Edit /etc/fstab
The exact syntax depends on the Card Reader. The best way is to make suitable entries
in /etc/fstab. The suitable entries for Card Reader would be:
/dev/sda /mnt/SMC auto noauto,user 0 0
/dev/sdb /mnt/CFC auto noauto,user 0 0
/dev/sdc /mnt/SDC auto noauto,user 0 0
/dev/sdd /mnt/MSC auto noauto,user 0 0
10. Create matching mount points in the actual filesystem:
mkdir /mnt/SMC
mkdir /mnt/CFC
mkdir /mnt/SDC
mkdir /mnt/MSC
11. Mount Card Reader:
mount /dev/sda
mount /dev/sdb
mount /dev/sdc
mount /dev/sdd
Note:
Note that the above entries assume you have no other SCSI devices.
If you do have other devices, then the USB disk may not be /dev/sda,
but could instead be /dev/sdb, /dev/sdc or some other device.
Aihe: Gembird Muistikortinlukija, 5,25", USB, FW, Audio, valk.[ratkaistu] (Luettu 2614 kertaa)
