1
Asentaminen ja käyttöönotto / Vs: Lubuntu ei asennu Fujitsu Amilo Li 1718 myllyyn
« : 29.12.14 - klo:20.10 »
acpi=off ja nyt lähti asennus pyörimään tutun kaavan mukaan.
Kiitos kaikille avusta.
JH
Kiitos kaikille avusta.
JH
Ubuntu 24.04.1 LTS | Lataa ja asenna | Tutustu yhteisöön | Blogi | Yritysten tarjoamat palvelut
Liity Ubuntu Suomen seuraan muualla: Discourse, Facebook, Mastodon, Matrix, Telegram, X
Tässä osiossa voit tarkastella kaikkia tämän jäsenen viestejä. Huomaa, että näet viestit vain niiltä alueilta, joihin sinulla on pääsy.
grep b43 /etc/modprobe.d/*
/etc/modprobe.d/blacklist.conf:# replaced by b43 and ssb.
dmesg | grep b43-
[ 2.158141] b43-pci-bridge 0000:06:02.0: enabling device (0000 -> 0002)
[ 15.277666] b43-phy0: Broadcom 4318 WLAN found (core revision 9)
[ 15.334628] b43-phy0: Found PHY: Analog 3, Type 2 (G), Revision 7
[ 15.728646] b43-phy0 ERROR: Firmware file "b43/ucode5.fw" not found
[ 15.728728] b43-phy0 ERROR: Firmware file "b43-open/ucode5.fw" not found
[ 15.728801] b43-phy0 ERROR: You must go to http://wireless.kernel.org/en/users/Drivers/b43#devicefirmware and download the correct firmware for this driver version. Please carefully read all instructions on this website.
*-network:0
description: Ethernet interface
product: BCM4401-B0 100Base-TX
vendor: Broadcom Corporation
physical id: 1
bus info: pci@0000:06:01.0
logical name: eth0
version: 02
serial: 00:16:d4:5c:4c:65
size: 100Mbit/s
capacity: 100Mbit/s
width: 32 bits
clock: 33MHz
capabilities: bus_master cap_list ethernet physical mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=b44 driverversion=2.0 duplex=full ip=192.168.1.40 latency=64 link=yes multicast=yes port=twisted pair speed=100Mbit/s
resources: irq:21 memory:d0000000-d0001fff
*-network:1
description: Network controller
product: BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller
vendor: Broadcom Corporation
physical id: 2
bus info: pci@0000:06:02.0
version: 02
width: 32 bits
clock: 33MHz
capabilities: bus_master
configuration: driver=b43-pci-bridge latency=64
resources: irq:22 memory:d0002000-d0003fff
E: dpkg was interrupted, you must manually run 'sudo dpkg --configure -a' to correct the problem.
ari@Arinpannu:~$ sudo dpkg --configure -a
Tehdään asetuksia: bcmwl-kernel-source (6.30.223.141+bdcom-0ubuntu2) ...
Removing old bcmwl-6.30.223.141+bdcom DKMS files...
-------- Uninstall Beginning --------
Module: bcmwl
Version: 6.30.223.141+bdcom
Kernel: 3.13.0-40-generic (i686)
-------------------------------------
Status: Before uninstall, this module version was ACTIVE on this kernel.
wl.ko:
- Uninstallation
- Deleting from: /lib/modules/3.13.0-40-generic/updates/dkms/
- Original module
- No original module was found for this module on this kernel.
- Use the dkms install command to reinstall any previous module version.
depmod...........
DKMS: uninstall completed.
------------------------------
Deleting module version: 6.30.223.141+bdcom
completely from the DKMS tree.
------------------------------
Done.
Loading new bcmwl-6.30.223.141+bdcom DKMS files...
First Installation: checking all kernels...
Building only for 3.13.0-40-generic
Building for architecture i686
Building initial module for 3.13.0-40-generic
Done.
wl:
Running module version sanity check.
- Original module
- No original module exists within this kernel
- Installation
- Installing to /lib/modules/3.13.0-40-generic/updates/dkms/
depmod..........
DKMS: install completed.
Segmentation fault