Tässä on /etc/ppp/peers/dna sisältö, jonka olen ottanut suoraan wiki-ohjeista
# Most GPRS phones don't reply to LCP echo's
lcp-echo-failure 0
lcp-echo-interval 0
# Keep pppd attached to the terminal:
# Comment this to get daemon mode pppd
nodetach
# Debug info from pppd:
# Comment this off, if you don't need more info
debug
# Show password in debug messages
show-password
# Connect script:
# scripts to initialize the GPRS modem and start the connection,
connect /etc/ppp/dna-connect-chat
# Disconnect script:
# AT commands used to 'hangup' the GPRS connection.
disconnect /etc/ppp/dna-disconnect-chat
# Serial device to which the GPRS phone is connected:
/dev/ttyACM0 # Data cable device file
#/dev/rfcomm0 # Bluetooth device file
# Serial port line speed
921600 # fast enough
#57600
# Hardware flow control:
# Use hardware flow control with cable, Bluetooth and USB but not with IrDA.
crtscts # serial cable, Bluetooth and USB, on some occations with IrDA too
#nocrtscts # IrDA
# Ignore carrier detect signal from the modem:
local
# IP addresses:
# - accept peers idea of our local address and set address peer as 10.0.0.1
# (any address would do, since IPCP gives 0.0.0.0 to it)
# - if you use the 10. network at home or something and pppd rejects it,
# change the address to something else
0.0.0.0:0.0.0.0
# pppd must not propose any IP address to the peer!
noipdefault
# Accept peers idea of our local address
ipcp-accept-local
# Add the ppp interface as default route to the IP routing table
defaultroute
# DNS servers from the phone:
# some phones support this, some don't.
usepeerdns
# ppp compression:
# ppp compression may be used between the phone and the pppd, but the
# serial connection is usually not the bottleneck in GPRS, so the
# compression is useless (and with some phones need to disabled before
# the LCP negotiations succeed).
novj
nobsdcomp
novjccomp
nopcomp
noaccomp
noccp
# The phone is not required to authenticate:
noauth
# Username and password:
# If username and password are required by the APN, put here the username
# and put the username-password combination to the secrets file:
# /etc/ppp/pap-secrets for PAP and /etc/ppp/chap-secrets for CHAP
# authentication. See pppd man pages for details.
user ""
password ""
#
mtu 1500
mru 1500
asyncmap 0xa0000
