13
« : 31.03.10 - klo:04.19 »
Elikkä itselläni on myös samanlainen ongelma kuin alkuperäisellä kirjoittajalla. Eli langaton yhteys ei toimi ollenkaan. Käytössä on Linux Mint 8 XFCE. Kun kirjoitan päätteeseen aikaisemmin mainitun litannian niin tulee:
lshw -C network; iwconfig; iwlist scan; cat /etc/modprobe.d/blacklist-ath_pci.conf
*-network UNCLAIMED
description: Network controller
product: RT3090 Wireless 802.11n 1T/1R PCIe
vendor: RaLink
physical id: 0
bus info: pci@0000:02:00.0
version: 00
width: 32 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list
configuration: latency=0
resources: memory:fbff0000-fbffffff
*-network
description: Ethernet interface
product: Atheros AR8132 / L1c Gigabit Ethernet Adapter
vendor: Attansic Technology Corp.
physical id: 0
bus info: pci@0000:01:00.0
logical name: eth0
version: c0
serial: e0:cb:4e:a6:aa:34
size: 100MB/s
capacity: 100MB/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress vpd bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=atl1c driverversion=1.0.0.1-NAPI duplex=full firmware=N/A ip=192.168.254.1 latency=0 link=yes multicast=yes port=twisted pair speed=100MB/s
resources: irq:28 memory:f7fc0000-f7ffffff ioport:ec00(size=128)
lo no wireless extensions.
eth0 no wireless extensions.
lo Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
# For some Atheros 5K RF MACs, the madwifi driver loads buts fails to
# correctly initialize the hardware, leaving it in a state from
# which ath5k cannot recover. To prevent this condition, stop
# madwifi from loading by default. Use Jockey to select one driver
# or the other. (Ubuntu: #315056, #323830)
blacklist ath_pci
Kiitos paljon jo etukäteen.
Näytä kirjoitukset
