Näytä kirjoitukset
1
Ubuntu tietokoneissa / Re: HP Deskjet 720c Printer - ei toimi ...
« : 24.01.06 - klo:21.24 »
Ratkaisu ongelmaan löytyi Ubuntun UK-sivulta:
http://ubuntuforums.org/showthread.php?t=75286&page=2&highlight=HP+710
_______________
Lainaus viestiketjusta:
I had have similar problem with a hp 710c
The solution was in the /etc/pnm2ppa.conf
I use pnm2ppa because 710 is only supported by this
In this document apears the following text
#-----------set the printer model---------------------------
# The printer model will normally be set by a -v <model> command
# line argument. Otherwise, if not set in the configuration file
# it defaults to the 710/720 series. Remove/comment out the line
# "version 0" below to get the default choice.
#
# If there is more than one "version" entry activated, the last one
# will be used. The printer version can also be set with the command line
# option e.g., "-v 720".
version
#version 720 # 710, 712, 722 also acceptable
#version 820
#version 1000
I only have to put the model in the version line
the tex now is
#-----------set the printer model---------------------------
# The printer model will normally be set by a -v <model> command
# line argument. Otherwise, if not set in the configuration file
# it defaults to the 710/720 series. Remove/comment out the line
# "version 0" below to get the default choice.
#
# If there is more than one "version" entry activated, the last one
# will be used. The printer version can also be set with the command line
# option e.g., "-v 720".
version 710
#version 720 # 710, 712, 722 also acceptable
#version 820
#version 1000
I suppose that with anothers printers the system configuration tool don't select the printer.
http://ubuntuforums.org/showthread.php?t=75286&page=2&highlight=HP+710
_______________
Lainaus viestiketjusta:
I had have similar problem with a hp 710c
The solution was in the /etc/pnm2ppa.conf
I use pnm2ppa because 710 is only supported by this
In this document apears the following text
#-----------set the printer model---------------------------
# The printer model will normally be set by a -v <model> command
# line argument. Otherwise, if not set in the configuration file
# it defaults to the 710/720 series. Remove/comment out the line
# "version 0" below to get the default choice.
#
# If there is more than one "version" entry activated, the last one
# will be used. The printer version can also be set with the command line
# option e.g., "-v 720".
version
#version 720 # 710, 712, 722 also acceptable
#version 820
#version 1000
I only have to put the model in the version line
the tex now is
#-----------set the printer model---------------------------
# The printer model will normally be set by a -v <model> command
# line argument. Otherwise, if not set in the configuration file
# it defaults to the 710/720 series. Remove/comment out the line
# "version 0" below to get the default choice.
#
# If there is more than one "version" entry activated, the last one
# will be used. The printer version can also be set with the command line
# option e.g., "-v 720".
version 710
#version 720 # 710, 712, 722 also acceptable
#version 820
#version 1000
I suppose that with anothers printers the system configuration tool don't select the printer.
